MIPI Camera Module & FPC Connector Sourcing from China
1 resources tagged with "Camera Module"
Camera modules in Chinese designs connect over MIPI CSI for cameras (and DSI for displays) using fine-pitch FPC/ZIF connectors, where pin count, lane configuration, and contact-side (top vs bottom) all have to match the host board. Signal integrity is the real constraint — MIPI D-PHY high-speed lanes are sensitive to FPC length, impedance, and a non-standard pinout will simply fail to enumerate. Connector pitches of 0.5mm and 0.3mm dominate, and getting the ZIF type and lane mapping wrong is a frequent integration error.
Sourcing a camera module means locking the MIPI lane count, FPC pin count, pitch, and contact orientation against your SoC's CSI interface before tooling. The pitfall is a connector that mates mechanically but maps the differential pairs to the wrong pins — we verify the pinout against the camera datasheet and check FPC trace impedance.
Wiki (1)
FAQ
Why does my MIPI camera module not enumerate after assembly?
The most common causes are a mismatched FPC pinout (top vs bottom contact), wrong lane count, or excessive FPC length degrading the high-speed lanes. Verify the pinout and lane mapping against the module datasheet first.
What FPC connector specs must match the camera module?
Pitch (0.5mm or 0.3mm), pin count, ZIF actuation type, and contact side. A connector with the right pitch but wrong contact orientation will not interface correctly.
Related Topics
Have a sourcing project in mind?
Tell us what you need. We respond within 24 hours, including weekends.