D-Sub Connectors from China: DB9, DB15, DB25
1 resources tagged with "Dsub"
D-Sub connector sourcing from China covers the classic DB9, DB15, DB25, and HD-15 shell sizes still used for serial, industrial, and legacy interface gear. The main sourcing variables are contact plating (gold flash vs. thicker gold over nickel), solder-cup vs. PCB-mount termination, and whether an EMC backshell is needed for shielded cabling. The most common quality issue from low-cost Chinese production is thin or inconsistent gold plating that fails after repeated mating cycles.
When you source D-Sub parts, specify the gold thickness in microinches (15µin is a practical floor for repeated mating) and confirm the shell material and plating for grounding. Mixing solder-cup and PCB versions in one BOM is a frequent ordering mistake — the mounting footprint and pin length differ.
Wiki (1)
FAQ
What gold plating thickness should I specify for D-Sub contacts?
For connectors that get mated repeatedly, 15µin of gold over nickel is a reasonable minimum, and 30µin for high-cycle industrial use. Cheap 'gold flash' parts can have under 3µin, which wears through quickly and causes intermittent contact.
Can I get shielded D-Sub connectors with EMC backshells?
Yes — metallized or die-cast metal backshells that provide 360-degree cable-shield termination are widely stocked in China. Confirm the backshell shell size matches your DB9/DB15/DB25 and that it provides a proper ground path to the connector shell.
Related Topics
Have a sourcing project in mind?
Tell us what you need. We respond within 24 hours, including weekends.